The battery is not fully charged before shipment. Before using the printer for the first time, charge it with the supplied USB Type-C cable and a 5V⎓1A power adapter.

Do not use a high-power fast charger.

When installing the ink cartridge for the first time:

1. Remove the protective film.
2. Use the dedicated cleaning wipe to gently wipe the printhead several times in the same direction.
3. Leave the cartridge to stand until the printhead is completely dry.
4. Use a dry, soft cloth to clean the electrical contacts on the ink cartridge and the spring-loaded pin contacts inside the printer.
5. Install the ink cartridge.

When the ink cartridge is not in use, remove it from the printer and place it back in the dedicated storage case. This helps prevent the ink from drying out and the nozzles from becoming clogged.

If the ink cartridge has not been used for an extended period:

1. Gently wipe the printhead using the supplied cleaning wipe or a moistened lint-free cloth. The lint-free cloth may be reused.
2. Allow the printhead to dry completely.
3. Reinstall the ink cartridge.
4. Run the [Clean] function in the InkWon App.

If the printhead is severely clogged:

1. Hold the ink cartridge with the printhead facing downward.
2. Immerse only the printhead in clean water to a depth of approximately 3–5 mm.
3. Leave it immersed for 10–30 minutes.
4. Remove the cartridge and carefully wipe it dry.
5. Leave it to stand until it is completely dry.
6. Reinstall the cartridge and clean.

Before installing the ink cartridge, use a dry, soft cloth to clean the electrical contacts on the cartridge and the spring-loaded pin contacts inside the printer. Reinstall the cartridge after cleaning.

1. Insert the paper print-side up; it will feed automatically.
2. Select a photo from your album, share it to the app, edit, and print.
3. Peel off the backing and stick it onto your desired surface.

1. Insert Tattoo Paper A print-side up; it will feed automatically.
2. Select a photo from your album, share it to the app, edit, and print.
3. Peel the backing from Tattoo Paper B and apply its adhesive side over the printed design.
4. Trim to the desired size, then peel off Paper B.
5. Place the printed design face-down on the skin and wet the paperthoroughly.
6. Wait briefly, then gently peel off Paper A to complete the transfer.

1. Insert the transfer paper print-side up; it will feed automatically.
2. Select a photo from your album, share it to the app, edit, and print.
3. Trim the design to size and peel off the watermarked backing.
4. Place the printed design face-up on the fabric and cover it withthe included protective sheet.
5. Heat press at 356-374°F (180-190°C) with medium-highpressure for 40-55 seconds.
6. Allow the design to cool completely, then remove the protective sheet.

1. Insert the holographic paper print-side up; it will feed automatically.
2. Select a photo from your album, share it to the app, edit, and print.
3. Peel off the backing and stick it onto your desired surface.

1. Insert the PET paper print-side up; it will feed automatically.
2. Select a photo from your album, share it to the app, edit, and print.
3. Peel off the backing and stick it onto your desired surface.